Operation Manual

By default, this menu offers 6 features, which can be changed or extended
to max. 12 by using Menu | Settings | Buttons.
On-board computer - allows the user to open the screen of the software
on-board computer.
Night mode - Enables/disables the night mode on AutoMapa.
Add to POI – by clicking this option, you can add your current location to
the list of points of interest - the GPS location or the point to its left or
right.
Detour – enables a detour around a section of the route over specified
distance.
Add to Favourites – as above; adds the selected point to Favourites.
Route - opens the relevant menu screen.
2.10.3 On-board computer
The "Computer" option is found in the "Your menu" and "Options" menu.
This option opens the panel of AutoMapa system's on-board computer.
The panel is shown to the left, while its contents have been explained
below:
The meter section shows the presently selected set of meters. The meters
comprise 4 independent sets of parameters displayed by the on-board
computer. They can be independently reset and selected for display. Each
set is located on a separate screen, which can be switched by selecting the
arrow keys. To reset the meters, select "Reset", from the bar at the bottom
of the screen. To start/pause the calculations performed by the "Computer",
use the "Pause" option. Meter sets A, B and C, are reset every time
AutoMapa is started and GPS is activated, while set D is a "permanent"
meter – it continues to run until manual reset.
On-board computer 2
The speed section displays the following data on the given meter, from the
left: maximum speed, average speed, and average speed including
stopping time.
The distance section displays the following data, from the left: the entire
distance travelled since system activation (or meter reset) and the distance
from the last stop. The route progress bar is displayed above, showing the
percentage of the route travelled so far (only if the route has been
previously mapped).
The time section displays the following data, from the left: total driving
time, total stopping time and driving time since the last stop.