Operation Manual

Information on current position
The information panel indicates the location and the current position (GPS-
based) or describes a point selected on the map.
By tapping on the panel, the user opens a window where the type of displayed
information can be selected (by clicking on a button representing a given type
of data).
The button representing a given type of data is deselected by clicking on the
"Clear" button.
The program enables the user to save three defined sets of data displayed in
the panel (the user can navigate between the sets by clicking on the number of
the set).
2.3.2 Main menu
The main menu features the key options for operating the AutoMapa system.
Some options are marked by a small rectangle on the left, which resembles a diode light. When greyed out, the rectangle
indicates that the given option is not active at the moment. When the rectangle is lit blue, the given option is active.
The menu features two screens – you can move between them with the use of < and > buttons on the bar at the bottom
of the screen. Press the X button to exit the menu.
Other main menu options:
Options – enables/disables the onboard computer, night mode, sounds, pilot and screen pivot.
Turn off GPS – Turn on/off GPS (in Expert mode, this menu is replaced with "GPS" option, which opens
the GPS menu).
POI – opens the POI menu with configuration of POI warnings, parameters of POI display or POI
management.
Settings - opens the settings menu. Refer to the "Settings" chapter.
Opens the "Go to/Search" menu, as discussed in the "»Go to« menu and searching destinations -
searching for addresses and points' section.
Opens the "Route" menu, where the user can perform operations on the mapped route, change the route
type and set up roadblocks.
Simplified menu – enables/disables the simplified menu.
AM'Traffic - Opens the AM'Traffic menu.
Accident - Opens the Accident menu.