Operation Manual

Configuring AutoMapa Traffic
The AutoMapa Traffic system enables users to avoid traffic
jams by processing real data on the anticipated driving
speeds on the roads. The system relies on both statistical
information (collected over longer periods of time) and online
data, which are collected and sent regularly.
The basic parameters of AM'Traffic can be configured in the
configuration window displayed upon the first start-up.
When the SmartRoutes (tm) option is selected, the traffic jam
avoidance mechanism is activated, and routes are mapped by
relying on traffic and jams statistics.
By choosing the LiveDrive! (tm) option, the user activates a
mechanism that avoids traffic jams by mapping routes based
on online data (3G/HSDPA). The LiveDrive! (tm) option may
imply additional data transmission charges quoted by the
telecommunications operator.
In devices without the Internet access, SmartRoutes (tm)
data can be synchronised with the use of the Amcenter
application, which can be downloaded at
http://www.AutoMapa.pl/, the "Support" - "Current
release" section, and http://www.miplo.pl/.
Detailed information can be accessed by tapping the "Details"
button.
Welcome screens
The display will show a welcome screen with fast access to
selected program options, allowing the user to start
navigation, start map browsing or specify the connection
parameters of a GPS receiver.
Go to - opens a destination selection menu that allows you to
immediately start navigation (upon correct configuration of
GPS device).
Usually, the device is detected automatically. If that is not the
case, manually configure the relevant parameters (port
number and baud rate) and, for an external GPS device, make
the relevant connections (applies also to Bluetooth
connection). The method and the correct parameters of the
connection should be described in the device's documentation.
Map – map browsing mode. This option offers the best
introduction to the application, and as such is recommended
for new users.
To disable the display of the welcome screen at each start-up, check the "Do not show this again" box.
2.2 Simplified and Expert menu
By default, program runs in simplified interface mode with access only to the most important system options. To
enable/disable simplified mode, select "Simplified menu" from the main menu of the application.
The differences between the two modes consist in the number of options available in the route menu, POI menu and "Go
to" menu.