User manual

5
2 INSTALLATION INSTRUCTIONS
2.1 Mounting the Control Assembly
Ensure that the controller is installed no less than 1.5m above the floor level.
The controller should be positioned to allow the user easy access to the push
buttons and to read the LCD display.
The controller can be positioned with the cable entry to the bottom or the top
depending on the cable routing.
The lid with the controller circuit board can be rotated through 180 degrees to
accommodate top or bottom cable entry.
Do not mount the controller on a warm surface or where it could be affected
by direct sunlight or other heat sources.
The mounting surface should be non-conducting or earth bonded and should
prevent access to the rear of the control.