User manual

3
Autolux ~ Universal Lighting Controller
Installation and User Manual
INTRODUCTION
This manual describes the Installation and Operation of the Autolux ~
Universal Lighting
Controller
This control must be installed according to the current IEE Wiring Regulations
and should include full disconnection means and fusing appropriate to the
connected loads.
1 TECHNICAL SPECIFICATIONS
1.1 Operating Environment
Operating temperature range:
0º C to 40º C
Operating humidity range:
0 to 90% RH.
Control IP rating:
IP30
Pollution degree:
II environment
Control safety construction:
Class II
Mains supply:
230Vac nominal, 200Vac to
265Vac actual, 50Hz.
On board supply fuse: 1AT
Rated impulse voltage: 2500V
Recommended control supply fuse:
3A
Rated impulse voltage: 2500V
Dimensions: 216mm X 124mm X
62mm
Conformities: EMC – 89/336/EEC
LVD – 73/23/EEC
1.2 Performance Specifications
An independently mounted
electronic control for surface
mounting.
Operation is by Class A software
and Type 1A action.
The mains supply to the electronic
circuit is to be protected by a fuse.
Remote switch inputs will be volt
free, 12Vdc/5mA
Occupancy sensor inputs are volt
free, normally closed (contacts
open on detection of occupancy) as
BW/MINI, BW/35, BW/CUR,
BW/MW and PIR/CM.
Maximum sensor rating: 90 mA
Push switch inputs are volt free,
normally closed (push to break).
Lux sensor readings are from a
photo-diode, operating at 12v dc as
UNI/LUX or UNI/LUX/WP.
Panic switch input is volt free,
normally open (contacts make for
panic operation)
Temperature sensor input is from a
thermistor sensor, as UNI/RS
.