Installation Manual

Title: Installation Specifications and User Manual, Radar
Sensors
Doc. No. E567781
INSTALLATION SPECIFICATION Rev. 001, Page 7 of 14
5.0 SPECIFICATIONS
5.3 Installation Specifications For Individual Sensors
5.3.1 Distance To The Bumper Material
The distance of the SLR sensor to the bumper shall be between 5 and
20 mm. If the distance is below 5 mm a significant signal loss occurs. If
the distance is larger, error ranges may appear within the close range.
Figure 5
5.3.2 Angle with respect to bumper material
The angle ϕ of the sensor with regard to the bumper should be 0
°
,
meaning the sensor should be installed parallel to the bumper. If this is
not possible, an angle of ±10° shall not be exceeded. Other
orientations need to be tested to confirm proper operation.
Figure 6
5 – 20mm
ϕ