Installation Manual

Title: Installation Specifications and User Manual, Radar
Sensors
Doc. No. E567781
INSTALLATION SPECIFICATION Rev. 001, Page 5 of 14
5.0 SPECIFICATIONS
5.2 SLR Sensor
(cont’d)
5.2.2 Detection Range / Azimuth Angle Measurement Range
Figure 2 displays the detection area of the SLR sensor. One should differentiate
between the detection area of the sensor and the angle measurement area. The
angle measurement area is reduced to ±40° around bore sight whereas the
detection area is ±65°. The detection area is related to the 10dB points, this
means the area where the signal amplitude is reduced by 10dB compared to bore
sight direction.
Within the detection area of the antennas there must not be metal parts like
screws, mounting brackets, license plate etc. The impact reducing foam material,
clips or fascia laminations has to be avoided in that area.
Figure 2