Installation Manual

Title: Installation Specifications and User Manual, Radar
Sensors
Doc. No. E567781
INSTALLATION SPECIFICATION Rev. 001, Page 3 of 14
1.0 PURPOSE/SCOPE
This document describes the specifications for installation of type SLR Radar Sensors.
2.0 MATERIALS/EQUIPMENT
N/A
3.0 APPLICABLE DOCUMENTS
Outline 6181175
DIN 40050-9 IP6K9K
IEC 68-2-6 Fc IEC 68-2-7 IEC68-2-10 IEC68-2-11 Ka
IEC 668-2-14Nb IEC 68-2-27 IEC 68-2-29 IEC68-2-30
IEC68-2-32 IEC68-2-38 IEC68-2-50 IEC68-2-51
IEC68-2-52 IEC68-2-56 IEC68-2-64Fh IEC529, 13.4
SAE J1211 SAE J1812 SAE J1879
4.0 DEFINITIONS
N/A
5.0 SPECIFICATIONS
5.1. Preface
This chapter describes the specifications to install short range SLR radar into bumpers.
These specifications shall be complied with to enable the specified characteristics of the
sensors as well as the complete system. Due to the various installation situations and
applications, a measurement check is required to verify the actual installation
implementation.
5.2. SLR Sensor
This chapter describes the characteristics relevant to the installation of SLR sensors in
the bumper. In addition general specifications are mentioned, which have to be followed
for each position to enable sufficient sensor performance. Therefore the following
guidelines are to be observed very carefully. See annex for performance
measurements.
5.2.1. Dimensions and Weight of the SLR Sensor
Figure 1 shows the dimensions of the SLR sensor (C-sample status) and details
the mounting of the sensor.
Please refer to “Outline 6181175” for detailed drawings.
Sensor weight: 190 grams max.