Installation Manual

Title: Installation Specifications and User Manual, Radar

Sensors

Doc. No. E567781

INSTALLATION SPECIFICATION Rev. 001, Page 11 of 14

6.0 SLR SENSOR SYSTEM

The following observations refer to the combination of several SLR sensors into one

sensor system. Many applications require several sensors networked together to

achieve the desired function. The sensors should be placed in the best possible

location for optimal coverage and range performance relative to the specific

applications. The optimal locations will be highly dependent on the desired applications

and the bumper dimensions. Autoliv can perform analysis and characterization to

determine sensor locations to best achieve a desired performance. Attention should

be paid that the installation specifications for individual sensors from chapter 5 are

maintained. Due to the various installation situations and applications, a measurement

check is required to verify the actual installation implementation.

6.1. Coordinate System

Figure 8 shows the coordinate system used for identifying sensor position in a

multi-sensor application. The arrows indicate positive values. The most

forward location on the bumper was selected as reference point. The Z-axis is

the vertical axis. Z-values are indicated from the ground surface.

Figure 8