User's Manual

Product Description, User Manual, Installation Guideline Doc. No. xxxxxxxxx
SENSOR MODULE, RADAR, SRR, NB Page 15 of 16
6.5.1 Sensor Height and Elevation Angle Settings
Please follow the following table for setting the elevation angle of the Side Blind Spot / Lane change
Assist sensor. The sensor shall not be placed below 500mm or above 600mm without review and
approval by Autoliv.
Sensor Height from Ground Elevation Angle Manufacturing Tolerance
550 – 650 mm 0° +1° / -1°
7.0 User information and Conformity to regulation
7.1.
Required notice to the user in the USA for Part 15 Devices per FCC
This device complies with part 15 of the FCC Rules and is identified as WU8NB24G1V2.
Operation is subject to the following conditions:
1. This device must not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Changes and Modifications not expressly approved by AUTOLIV can void your authority to operate this
equipment under Federal Communications Commission’s rules.
RADIO AND TELEVISION INTERFERENCE
NOTE: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
7.2.
Required notice to user in Canada per RSS-gen issue 3
This device complies with Industry Canada license-exempt RSS standard(s) and is identified with the
marking IC CANADA 310.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.