Installation Instructions

Title: Installation Specifications and User Manual, Radar
Sensor, 24 GHz
Doc. No. E E814702
INSTALLATION SPECIFICATION Rev. 000, Page 7 of 16
5.2 24 GHz Sensor
(cont’d)
5.2.4 Non-Conductive material keep-out zone, Angle Elevation (cont’d)
Figure 3a
5.2.5 Bracket to sensor retention features keep out zone
Bracket retention features which are used to hold the sensor into the bracket,
shall be made of non-conductive material, and protrude into the face of the
sensor radome with enough overlap to overcome any variability in the bracket (ie.
bracket to sensor gap, material distortion). A general guideline is to create a
retention feature with overlap which is positioned in the allowable shaded area
outlined below (Figure 3b).
Figure 3b