Installation Instructions

Title Installation Specifications and User Manual, 24 GHz
Radar Sensor, Model 6208428
Doc. No. E814702
INSTALLATION SPECIFICATION Rev. 000, Page 2 of 16
1.0 PURPOSE/SCOPE
This document describes the specifications for installation of type 24 GHz Radar Sensors.
2.0 MATERIALS/EQUIPMENT
N/A
3.0 APPLICABLE DOCUMENTS
Outline see Fig 1.
DIN 40050-9 IP6K9K
IEC 68-2-6 Fc IEC 68-2-7 IEC68-2-10 IEC68-2-11 Ka
IEC 668-2-14Nb IEC 68-2-27 IEC 68-2-29 IEC68-2-30
IEC68-2-32 IEC68-2-38 IEC68-2-50 IEC68-2-51
IEC68-2-52 IEC68-2-56 IEC68-2-64Fh IEC529, 13.4
SAE J1211 SAE J1812 SAE J1879
4.0 DEFINITIONS
N/A
5.0 SPECIFICATIONS
5.1. Preface
This chapter describes the specifications to install 24 GHz radar sensors into vehicles.
These specifications shall be complied with to enable the specified characteristics of the
sensors as well as the complete system. Due to the various installation situations and
applications, a measurement check is required to verify the actual installation
implementation.
5.2. 24 GHz Sensors
This chapter describes the characteristics relevant to the installation of 24 GHz sensors
in vehicles. Note that there are three types of 24 GHz sensors, each supporting
various applications as follows:
24 GHz Mid Range Radar (MRR) – used of medium range applications 24 GHz Short
Range Radar (SRR) – used of short range applications 24 GHz Multi Mode sensor
(MMS) – combined SRR and MRR functionality.
Unless otherwise stated the specifications contained in this document apply to all 24
GHz sensor types.
In addition general specifications are mentioned, which have to be followed for each
position to enable sufficient sensor performance. Therefore the following guidelines are
to be observed very carefully. See annex for performance measurements.