Installation Manual

Title: Installation Specifications and User Manual, Radar
Sensor, C6
Doc. No. E805913
INSTALLATION SPECIFICATION Rev. 003, Page 11 of 12
5.3.8 Mounting Bracket Design and Vehicle Mounting
In addition to the mounting bracket design being consistent with the keep out zones
described in this document the bracket must also provide the following:
- The mounting bracket shall prevent sensor movement or vibration in x, y, or z
direction with respect to the bracket.
- The bracket shall be mounted to vehicle in manner to prevent sensor
movement or vibration in x, y, or z direction with respect to the fascia surface that is in the
sensor field view (sensor keep out zone). To achieve this it is preferred that the bracket be
firmly attached to the inner surface of the fascia.
- For cases where a chassis mounted bracket is only option there shall be design
considerations in place to prevent movement or vibration in x, y, or z direction with respect to
the fascia surface that is in the sensor field view (sensor keep out zone).
6.0 C6 SENSOR SYSTEM
The following observations refer to the combination of several C6 Sensors into one
sensor system. Many applications require several sensors networked together to
achieve the desired function. The sensors should be placed in the best possible
location for optimal coverage and range performance relative to the specific
applications. The optimal locations will be highly dependent on the desired
applications and the bumper dimensions. Autoliv can perform analysis and
characterization to determine sensor locations to best achieve a desired performance.
Attention should be paid that the installation specifications for individual sensors from
chapter 5 are maintained. Due to the various installation situations and applications, a
measurement check is required to verify the actual installation implementation.