Installation Guide

Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual vO1
1.2 List of applicable FCC rules
FCC Part 15 Subpart C 15.249& 15.209
1.3 Specific operational use conditions
The module is a Bluetooth module
Operation Frequency: 2402-2480MHz
Number of Channel: 79
Modulation: GFSK
Type: PCB Antenna
Gain: 1 dBi Max.
The module can be used for mobile or portable applications with a maximum 1.0dBi antenna. The host
manufacturer installing this module into their product must ensure that the final composit product complies with the
FCC requirements by a technical assessment or evaluation to the FCC rules, including the transmitter operaition.
The host manufacturer has to be aware not to provide information to the end user regarding how to install or remove
this RF module in the user's manual of the end product which integrates this module. The end user manual shall
include all required regulatory information/warning as show in this manual.
1.4 Limited module procedures
The module is a limited module,The host integrator installing the module into their product, a Class II Permissive
Change (C2PC) must be filed with the FCC, or a new FCC authorization must be applied.
1.5 Trace antenna designs
Not applicable. The module has its own antenna, and doesn't need a host's printed board microstrip trace antenna
etc.
1.6 RF exposure considerations
The module must be installed in the host equipment such that at least is maintained between the antenna and users
1
body; and if RF exposure statement or module layout is changed, then the host product manufacturer required to
take responsibility of the module through a change in FCC ID or new application. The FCC ID of the module cannot
be used on the final product. In these circumstances, the host manufacturer will be responsible for re-evaluating the
end product (including the transmitter) and obtaining a separate FCC authorization.
1.7 Antennas
Antenna Specification are as follows:
Type: PCB Antenna
Gain: 1 dBi
This device is intended only for host manufacturers under the following conditions:
The transmitter module may not be co-located with any other transmitter or antenna;
The module shall be only used with the internal antenna(s) that has been originally tested and certified with this
module. The antenna must be either permanently attached or employa 'unique
1
antenna coupler.
As long as the conditions above are met, further transmitter test will not be required. However, the host
manufacturer is still responsible for testing their end-product for any additional compliance requirements required
with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
2.8 Label and compliance information
Host product manufacturers need to provide a physical or e-label stating ''Contains FCC ID: 2A6SS-JIERUIBT”
with their finished product.