Manualshelf

2017

ManualsBrandsAutodesk ManualsApplicationsSmoke
891892893894895896897898899900
Table Of Contents
(a) Geometry box (b) Multiple button (c) Line Type box
3 Select the type of line you want to draw from the Line Type box.
To:Select:
Paint a line at a specific angle. This option displays a field in which you enter the
angle in degrees.
Angle
Paint vertical lines.Vertical
Paint horizontal lines.Horizontal
Paint lines at any angle with no constraint.FreeForm
4 If you selected Angle, enter a degree in the field.
5 To draw single lines, move to the canvas and click, drag, and release.
A brush stroke is painted along the line.
6 To draw multiple lines, enable Multiple, move to the canvas, and click to place the start point of the
first line. Click again to draw the end point. Continue clicking to place additional points and draw
more lines.
7 To end multiple lines, click below the timebar or on the menu panel to turn the option off.
The brush strokes are painted along the lines.
Painting Rectangles
Use the Rectangle option to draw rectangles or squares.
To paint a rectangle or square:
1 Click Geometry to display the Geometry menu.
2 Select Rectangle from the Geometry box.
The Equal Sides button appears.
878 | Chapter 20 Painting