2017

To replace a clip:
1 Drag a clip from the Media panel into the ConnectFX schematic.
2 Release the clip on top of an existing schematic clip, once you see a replace icon.
The clip is replaced.
TIP If the clip proxy is black after replacing, right-click the clip and select Reset to reset the timing offset of
the clip.
Alternatively, press Shift and double-click a clip in the schematic to open the workspace in Clip Select
mode, where a new clip can be selected to replace the ConnectFX clip.
To find a clip on the reels:
1 In a schematic, right-click the clip to be located.
2 Select Find in Reels.
The view switches to Reels and the specific clip is highlighted.
To find a clip in a schematic:
1 In the Media panel, right-click the clip to be located.
2 Select Find in Schematic.
The view switches to the correct schematic and the specific clip is highlighted.
About Adaptors
Because the ConnectFX environment exclusively supports 8-bit or 16-bit fp media, 10 and 12-bit media
needs to be converted to 16-bit fp. While this can be done manually through the Resize or the LUT Editor,
you can apply Adaptors, which automatically apply the proper bit depth conversion(s), when you bring
media into ConnectFX. This greatly reduces the number of mismatches in ConnectFX (red dots on nodes),
without the need to manually convert anything.
NOTE Manually applying a LUT or Resize makes the adaptor(s) disappear.
Working with Clips in the Process Tree | 407