2017

To add node connection break points:
1 From the Tools box, select Add Points.
2 In the schematic, click the connection line between two nodes where you want to add a break point.
You can add multiple break point in a connection.
TIP You can press and hold the Add keyboard shortcut to add a point instead of selecting Add Points in the
Tools box. By doing so, the selected tool in the Tools box remains after you release the shortcut.
3 Drag the newly created point or points and position them as needed.
You can also move points after they are created in Select mode from the Tools box.
4 To delete points, select Delete from the Tools box, and click the point.
You can also delete points using the Extract Node From Link keyboard shortcut.
Selecting Nodes in the Schematic
Use the following keyboard shortcuts to help you select and work with nodes in the ConnectFX schematic.
NOTE These following keyboard shortcuts are based on the default User Profile for the application, and may
change if you select a different profile at startup or during a session, in the Project and User Settings window.
Do this:To:
Click node.Select a node.
Press Command, then click and drag a rectangular selection around the
nodes.
Select multiple nodes.
Click on an empty space in the schematic, or press Command and click-
drag on an empty space in the schematic.
Deselect everything.
Press Command and click the nodes you want to add or remove.Add or remove nodes from a selection.
402 | Chapter 14 Procedural Compositing with ConnectFX