2017

Creating a Subclip in the Player
You can create subclips anywhere that you have access to the source clip (i.e. Thumbnail, Player, Triptych
and Source-Sequence viewers).
NOTE Remember you will need handles for trimming and effects that you apply later. It is recommended to cue
the tape a couple of seconds before the desired footage starts.
To create a subclip in the player:
1 Click the Timeline tab.
2 Set the positioner to the in point.
3 Click the In button.
The start of the sub-clip is marked.
4 Set the positioner to the end point.
5 Click the Out button.
The end of the sub-clip is marked.
The section of the clip that is between the In and Out marks is the sub-clip.
6 From the Clip menu, select Create Subclip.
The subclip is created as a new clip in the Media library. It has the original name and append
("_Subclip_") with an incremented number, starting with ("001").
Accessing Clip Information
Any viewer contains the following information located at the bottom right corner of the viewer:
■ Name of the viewer OR name of the clip,
■ Resolution and aspect ratio of the clip,
■ LUT information of the clip (if LUT has been set).
Also, by alt-clicking on a clip proxy you will see additional clip information detail
Player options
To access the options below, select the Player Options box in the View menu bar.
Select between playing all frames and playing back media in real-time mode, with or without Timeline FX.
When playing back all frames, cache frames from memory to increase performance. If the current project
uses real-time deliverables, select the resolution at which to play back media.
To Do This:Select This:
Play back all frames as quickly as they are rendered, even if it results in
lack of audio synchronization.
Play All Frames
Play back frames synchronized with audio. May result in some frames being
dropped.
Play Real-Time
304 | Chapter 8 Playing Back Media