2017

Duration field Displays the duration of the timewarp in frames or timecode. Editable.
Duration Speed field This locked field displays the speed value corresponding to the duration set in the
Duration field. Non-editable.
Strobe Settings
Repeat field Displays the number of frames or fields to be repeated to create a strobe effect. The strobe effect
is applied after the timewarp effect, so any speed or timing animations are respected when applying the
strobe effect. Editable.
Anchoring Settings
Anchoring box Select where to set the anchor frame so that its timing is not affected when modifying a
timewarp.
To anchor:Select:
The In frame value as the value not to change.Start
The Out frame value as the value not to change.End
Both the In and Out frame values. In this case, any speed changes affect the length of
the media (and the state of the Ripple button has an effect).
Start and End
Repeat Mode Settings
Repeat Mode box Select how out of range timing values are handled.
To:Select:
Only use timing values within the range of the segment. The Timing field is displayed in
red when reaching a timing value that is impossible to achieve with the current source
clip frame range (heads and tails).
Lock to Segment Range
Not clamp or limit the timing values, by repeating the last frame when reaching the last
frame of the segment range.
Repeat Last Frame
Trim the segment (based on the selected ripple settings), when any modification to the
speed or timing cause the range of source frames to exceed the available frames.
Trim Segment
Timewarp | 1211