2013

NOTE The network log file must be in a shared folder where users of the
deployment have read-write access. Otherwise, log data for user
installations cannot be written to the log file. For more information
regarding log files, refer to
Specify Log File Locations (page 32).
5 Click Next.
6 On the Product Information page, use the Product Language
drop-down if required (see
Change Deployment Language (page 34)).
7 Select a
License Type (page 25) and enter your Serial Number and
Product Key. If the data is valid, green check marks appear. Click Next.
8 Review the Autodesk software license agreement for your country or
region. You must accept this agreement to proceed with the installation.
Choose your country or region, click I Accept, and then click Next.
NOTE If you do not agree to the terms of the license and want to terminate
the installation, click Cancel.
9 On the Configure Deployment page, select the products to deploy.
10 If you need to configure settings for a product, click the product name
to open the configuration panel, where you can review and change
settings. See Configure Individual Products for Deployment (page 35).
NOTE The configuration settings you choose apply to every instance of the
product installed from the deployment. After the deployment is created,
these settings can be changed only by modifying the deployment.
Click the product name to close the configuration panel.
11 Click Create.
After the deployment is created, the Deployment Configuration
Complete page opens, presenting useful paths to the new deployment
and a link for registering products online.
12 After you have finished using this screen, click Finish.
Modify a Deployment
After a deployment is created, it may be necessary to modify the deployment
for some client workstations.
Inside each deployment folder is a Tools folder that contains a shortcut (.LNK
file) named Create & Modify a Deployment. You can use this shortcut to
■ Create a new deployment configuration
42 | Chapter 3 Network Administration and Deployment