2013
Table Of Contents
- Contents
- Installation Process
- Stand-Alone Installation
- Network Administration and Deployment
- Installation Questions
- General Installation Questions
- What if I have lost my serial number or product key?
- Why do I need to activate a product after installation?
- Can I install Autodesk products from a website?
- How do I register and activate Autodesk Navisworks?
- How do I switch my license from stand-alone to network or network to stand-alone?
- Where can I find product license information after installation?
- How can I check my graphics card driver to see if it needs to be updated?
- When performing a Typical installation, what gets installed?
- How do I share the Autodesk Navisworks settings on a site and project basis?
- How do I change which exporter plugins are installed?
- Deployment and Networking Questions
- Where should deployments be located?
- When should I select all products for the administrative image, and can I add products later?
- Where can I check if service packs are available for my software?
- How do I choose between 32-bit and 64-bit deployments?
- Where do I find my server name?
- What is an administrative image (MSI) file?
- How do I extract an MSP file?
- How should I configure a network license server for a firewall
- Licensing Questions
- Uninstall and Maintenance Questions
- How can I see what is included in a default installation?
- Is it possible to change the installation folder when adding or removing features?
- How do I install tools and utilities after installing my product?
- When should I reinstall the product instead of repairing it?
- Do I need the original media to reinstall my product?
- When I uninstall my software, what files are left on my system?
- General Installation Questions
- Glossary
- Index
NOTE If you do not agree to the terms of the license and want to terminate
the installation, click Cancel.
4 On the Product Information page, add language pack(s) from the
Product Language drop-down, if required (see
Change Product Lan-
guage
(page 7)).
IMPORTANT After you leave the Product Information page of the installer,
the menu for selecting a language or adding a language pack is disabled. If
you later decide to change the language or add a language pack, you cannot
go back to the Product Information page and use the menu. Instead,
you must cancel the installation, start the installer again, and then make the
correct language selection on the Product Information page.
5 Select the License Type (Stand-Alone or Network) and enter your
serial number and product key, then click Next.
NOTE This step does not apply to Autodesk Navisworks Freedom installation.
6 On the Configure Installation page, select the products to install.
7 Click the product name to open the configuration panel where you can
review and change settings. See
Configure and Install (page 9). After
you have configured the settings as required, click the product name to
close the configuration panel.
8 If required, use the Installation PathBrowse button to select the
drive and location where product will be installed.
9 Click Install. The wizard installs the products you selected using your
Custom installation settings.
10 Click Finish.
Launch Autodesk Navisworks
You can start Autodesk Navisworks in the following ways:
■ Desktop shortcut icon. When you install Autodesk Navisworks, a
shortcut icon is placed on your desktop. Double-click the Autodesk
Navisworks icon to start the program.
■ Start button. Click Start ➤ All Programs ➤ Autodesk ➤ [product
name] 2013.
■ Location where Autodesk Navisworks is installed. If you have
administrative permissions, you can run Autodesk Navisworks in the
location where you installed it. If you are a limited-rights user, you must
Install and Run Autodesk Navisworks 2013 | 13