2012

Table Of Contents
Display Units Page
Use this page to customize the units used by Autodesk Navisworks.
Linear Units Use the drop-down list to select the desired linear value. Meters
are used by default.
Angular Units Use the drop-down list to select the desired angular value.
Degrees are used by default.
Decimal Places Specifies the number of decimal places used by units.
Fractional Display Precision Specifies the level of fraction used by units. This
box is enabled for fractional units only.
Selection Page
Use the options on this page to configure the way geometry objects are selected,
and highlighted.
Pick Radius Specifies the radius, in pixels, that an item has to be within in
order for it to be selected.
Resolution Specifies the level of selection used by default.
When you click in the Scene View, Autodesk Navisworks requires a starting
point for the object path in the Selection Tree box to identify the selected
item. You can choose one of the following options:
Model - the object path starts at the model node; as a result, all objects
in the model are selected.
Layer - the object path starts at the layer node; as a result all objects within
a layer are selected.
First Object - the object path starts at the highest level of objects below
the layer node, if applicable.
Last Object - the object path starts at the lowest level of objects in the
Selection Tree. Autodesk Navisworks looks for composite objects first,
and if none are found, the geometry level is used instead. This is the default
option.
Last Unique - the object path starts at the first unique level of objects
(not multiple-instanced) in the Selection Tree.
Geometry - the object path starts from the geometry level in the
Selection Tree.
Options Editor Dialog Box | 709