2012

Test Selection Click this button to test the set you chose. All objects that
satisfy the criteria will be selected in the model.
Appearance Area
Use this area to configure the appearance overrides that will be associated
with an appearance profile selector.
Color Use the color picker to choose the color that will be used to override
appearance of the selected objects.
Transparency Use the slider to choose transparency level (0 to 100%) that
will be used to override appearance of the selected objects. You can also type
the value into the corresponding box. A higher value makes objects more
transparent; a lower value makes objects more opaque.
Selector List
The Selector List shows all configured appearance profile selectors. You can
update settings for each of the selectors in the list, but you cannot move the
selectors around. To correct the order of selectors, you may need to delete
them from the list and start again.
Buttons
Add Use the color picker to choose the color that will be used to override
appearance of the selected objects.
Update You can modify the object selection criteria and the appearance
settings for each of the selectors added to the Selector list. To save the changes,
click the Update button.
Delete Clicking this button deletes the selected appearance selector in the list.
Delete All Clicking this button deletes all appearance selectors in the list. You
will be prompted to confirm your decision.
Load Enables you to open and use a previously saved appearance profile.
Save Enables you to save the current appearance profile with the .dat file
extension.
Run Sequentially applies all selectors in the current appearance profile to your
model.
Ribbon: Home tab ➤ Tools panel ➤ Appearance Profiler
682 | Chapter 16 Reference