2012

Table Of Contents
It is possible to override the Start and End dates that the simulation runs
between. Selecting the Override Start/End Dates check box enables the
date boxes and allows you to choose the start and end dates. By doing this,
you can simulate a small sub-section of the overall project. The dates will be
shown on the Simulate tab. These dates will also be used when exporting
animations.
You can define the Interval Size to use when stepping through the simulation
using the playback controls. The interval size can be set either as a percentage
of the overall simulation duration or to an absolute number of days or weeks,
and so on.
Use the drop-down list to select the interval unit, then use the Up and Down
arrow buttons to increase or decrease the interval size.
Overview of TimeLiner Tool | 621