2012

Table Of Contents
2 On the Installation wizard, if required, select an alternate language
for the Installation wizard from the Installation Instructions
drop-down, and then click Install.
3 Review the Autodesk software license agreement for your country or
region. You must accept this agreement to proceed with the installation.
Choose your country or region, click I Accept, and then click Next.
NOTE If you do not agree to the terms of the license and want to terminate
the installation, click Cancel.
4 On the Product Information page, select the License Type
(Stand-Alone or Network) and enter your serial number and product
key, then click Next.
5 On the Configure Installation page, select the products to install,
and if required add a language pack(s) from the Product Language
drop-down (see
Choose a Language (page 33)).
6 Click the product name to open the configuration panel where you can
review and change settings. See
Configuration (page 34). After you have
configured the settings as required, click the product name to close the
configuration panel.
7 If required, use the Installation PathBrowse button to select the
drive and location where product will be installed.
8 Click Install. The wizard installs the products you selected using your
Custom installation settings.
9 Click Finish.
Launch Autodesk Navisworks
Assuming that youve followed all of the previous steps outlined in this Quick
Start section, you can launch Autodesk Navisworks and start taking advantage
of its new and updated features.
You can start Autodesk Navisworks in the following ways:
Desktop shortcut icon. When you install Autodesk Navisworks, a
shortcut icon is placed on your desktop. Double-click the Autodesk
Navisworks icon to start the program.
Start button. Click StartAll ProgramsAutodeskNavisworks
Simulate 2012Autodesk Navisworks Simulate 2012.
Location where Autodesk Navisworks is installed. If you have
administrative permissions, you can run Autodesk Navisworks in the
Quick Start to Stand-Alone Installation | 39