2012

Table Of Contents
2 On the Installation wizard, if required, select an alternate language
for the Installation wizard from the Installation Instructions
drop-down, and then click Install.
3 Review the Autodesk software license agreement for your country or
region. You must accept this agreement to proceed with the installation.
Choose your country or region, click I Accept, and then click Next.
NOTE If you do not agree to the terms of the license and want to terminate
the installation, click Cancel.
4 On the Product Information page, select Stand-Alone and enter
your serial number and product key, then click Next.
5 On the Configure Installation page, select the products to install,
and if required add a language pack(s) from the Product Language
drop-down (see
Choose a Language (page 33)).
6 If required, use the Installation PathBrowse button to select the
drive and location where product will be installed.
7 Click Install. The wizard installs the products you selected using a
Typical installation, which installs the most common application
features. To see which features are included in a Typical installation,
refer to Typically Installed Features (page 72).
NOTE By default, the Installation wizard automatically enables the exporter
plugins for all third-party products already installed on your computer.
8 Click Finish.
Install Autodesk Navisworks Using Configured
Values
With this installation method, you can fine-tune exactly what gets installed.
You can alter the license type, the installation type, the install path, and
specify the location of the Project and Site folders.
To install Autodesk Navisworks using configured values on a stand-alone
computer
1 Close all running applications on your computer and start the
Installation wizard.
38 | Chapter 2 Installation