2012

Table Of Contents
NOTE 0,0,0 represents world up.
Scale
X, Y, Z Enter the scaling factor around X, Y, and Z axis; 1 being the current
size, 0.5 half, 2 being double and so on.
cX, cY, cZ Enter the X, Y, and Z coordinate values to move the origin (or
center point) of the scaling into this position.
Color
Color This check box indicates whether or not clicking Capture Keyframe
will record color change in the keyframe.
Unchecking this check box resets the color back to its original state.
By default, Autodesk Navisworks unchecks this check box every time you
create an animation set. Within one and the same animation set, once this
check box is selected, it stays selected, until you manually uncheck it.
R, G, B Enter the Red, Green, and Blue values for the new color.
If you dont want to enter the Red, Green, and Blue values manually, click
this button, and select the desired color.
Transparency
Transparency This check box indicates whether or not clicking Capture
Keyframe
will record transparency change in the keyframe.
Unchecking this check box resets the transparency back to its original state.
By default, Autodesk Navisworks unchecks this check box every time you
create an animation set. Within one and the same animation set, once this
check box is selected, it stays selected, until you manually uncheck it.
% Enter the value to adjust the transparency level (0 to 100%). A higher value
makes the element more transparent; a lower value makes the element more
opaque.
If you dont want to enter the transparency value manually, use this
slider to adjust the transparency level.
See also:
Gizmos (page 160)
510 | Chapter 12 Animate Objects