2012

Table Of Contents
Measuring
You can use measuring tools to make linear, angular, and area measurements,
and to automatically measure the shortest distance between two selected
objects.
NOTE When you measure, you must click on a point on an item to register a point
- clicking on the background will not register anything. You can reset a measure
command at any time by right-clicking instead of left-clicking in the Scene View.
This starts the measure command again with no points registered, just as if you
had chosen a new measurement type.
Endpoints of standard measuring lines are represented as small cross symbols
in the Scene View, and all lines being measured by a simple line between
registered points.
Endpoints of measuring lines that are snapped to center lines are represented
as cross symbols with additional CL markers.
You can change the color and thickness of measuring lines, and toggle the
display of dimension label in the Scene View.
Measure Tools | 393