2012

Table Of Contents
Alternatively, navigate to a different location in the Scene View. The
triangular marker in the reference view changes its position to match
the camera position in the Scene View.
3 To manipulate a reference view, right-click anywhere in the Section
View window. Use the shortcut menu to adjust the view as desired.
Command entry: CTRL + F10
Right-clicking the Section View or the Plan View window opens the
shortcut menu with the following options.
DescriptionOption
Enables you to set the reference view to one
of the preset viewpoints. Choose from: Top,
Look From
Bottom, Front, Back, Left, Right, or
Current Viewpoint. Selecting the Cur-
rent Viewpoint option sets the reference
view to the view in the active navigation
viewpoint.
Sets the active navigation viewpoint to the
view in the reference view.
Update Current Viewpoint
Opens the Edit Viewpoint dialog box,
and enables you to modify the settings for
the corresponding reference view.
Edit Viewpoint
Instructs Autodesk Navisworks to match
aspect ratio of the reference view to that of
Lock Aspect Ratio
the current viewpoint in the Scene View.
The matching is done even when you resize
the window with the reference view. This
will usually give gray strips either to the top
and bottom, or to either side of the refer-
ence view.
Redraws the reference view based on the
current setting. Reference view drawing
Refresh
uses software OpenGL and so can take a
couple of seconds for large models.
Navigate a Scene | 309