2012

To spin model on a turntable
1 On the navigation bar, click Turntable on the Navigation Mode
toolbar.
2 Drag the left mouse button left and right, or use the left and right cursor
keys, to spin the turntable left and right respectively.
NOTE Holding down the SHIFT key or spinning the mouse wheel, temporarily
enables normal Zoom mode. Holding down the CTRL key, temporarily
enables normal Pan mode.
3 To tilt the turntable up and down, spin the mouse wheel, or use the up
and down cursor keys.
Menu: Classic user interface: Viewpoint ➤ Navigation
Mode ➤ Turntable
Command entry: CTRL + 0
View All Tool
Makes the complete model fit into the Scene View.
Using this function dollies and pans the camera so that the entire model is
shown in the current view, which is very useful if you get lost inside a model
or lose it completely.
Occasionally, you may get a blank view. This is usually because there are items
that are very small in comparison to the main model, or items that are located
a long way away from the main model. In these cases, right-click an item in
the Selection Tree and click Zoom Selected to find your way back to the
model before trying to figure out which items are “lost”.
272 | Chapter 5 Explore Your Model