2012

Dragging the slider to the left decreases the walking speed; dragging the
slider to the right increases the walking speed.
4 Click OK.
To constraint the Walk tool to the world up vector
1 Display a wheel.
2 Right-click the wheel, and click SteeringWheels Options.
3 In the Options Editor, the SteeringWheels page under the Interface
node, select the Constrain Walk Angle check box in the Walk Tool
area.
4 Click OK.
Movement when walking is done parallel to the world up of the model.
To make the Walk tool use the viewpoint linear speed
1 Display a wheel.
2 Right-click the wheel, and click SteeringWheels Options.
3 In the Options Editor, the SteeringWheels page under the Interface
node, select the Use Viewpoint Linear Speed check box in the Walk
Tool area.
4 Click OK.
To adjust the height of the current view from the Walk tool
1 Display one of the Full Navigation wheels or the mini Tour Building
wheel.
2 Click and hold down the Walk wedge.
The cursor changes to the Walk cursor and the Center Circle icon is
displayed.
3 Do one of the following:
■ Press and hold down the SHIFT key to enable the Up/Down tool;
drag up or down.
■ Press and hold down the UP ARROW or DOWN ARROW key.
4 Release the button on your pointing device to return to the wheel.
260 | Chapter 5 Explore Your Model