2009

Table Of Contents
Select the Step Size check box, and enter the step value in the box below. This value is
then used when moving the section planes. If the Step Size check box is left clear, the
section planes will move at percentage intervals.
Click OK to close the dialog box, and save the changes.
3. To switch the plane on, click Enable/Disable on the Sectioning toolbar. Clicking it again,
switches the plane off.
4. Once the plane is switched on, choose one of the 7 planes that this section plane will cut:
Align View - aligns section plane with camera view plane.
Align Bottom - aligns section plane with bottom of model.
Align Top - aligns section plane with top of model.
Align Front - aligns section plane with front of model.
Align Back - aligns section plane with back of model.
Align Left - aligns section plane with left of model.
Align Right - aligns section plane with right of model.
Note:
Each plane for each section remembers its position, so the slider will move when you choose
Sectioning
219