2012

NOTE This dialog box is only available for 3D models.
Pan Settings
Pan Min and Pan Max Define how far the model can be revolved (as though
on a turntable).
Pan Initial Defines where you view the model from at the start (again, as
though on a turntable, 0 or 360 would be the same point at the opposite side
and 180 would be where the camera is now).
Pan Frame No. The number of frames to be used to revolve the model from
the Pan Min position to the Pan Max position.
Tilt Settings
Tilt Min and Tilt Max Define how far the model can be tilted (backwards
and forwards from its current position).
Tilt Initial Defines where you view the model from at the start (assuming you
are looking at the model straight, -90 would be from the bottom and 90 from
the top).
Tilt Frame No. The number of frames to be used to tilt the model from the
Tilt Min position to Tilt Max position.
Pointing device: Export Rendered Image dialog box ➤ Type drop-down
list ➤ QTVR Object Movie and click OK
Section Plane Settings Dialog Box
Use this dialog box to edit section plane settings.
NOTE This dialog box is only available for 3D models.
You can set the visibility and alignment of each section plane, select the
current plane, and link visible section planes together.
Link Section Planes Enables you to link section planes together.
Controls the visibility of the corresponding section plane. When the check
box is selected, the section plane's effect is visible (that is, it cuts the scene).
When the check box is deselected, the section plane's effect is not visible and
all other controls for that plane are disabled.
830 | Chapter 17 Reference