2012

Convert Work Surfaces Select this check box to convert Work Surfaces. When
this check box is clear, the file reader ignores Work Surfaces. This is the default
option.
Load assembly with last active representation Select this check box to load
Inventor assembly with the last active representation. When this check box
is clear Inventor files are opened as in Autodesk Navisworks 2011.
See also:
Inventor File Reader (page 183)
Leica Page
Use this page to adjust the options for the Leica Scan file reader.
Sample Rate Specifies the frequency of points extracted from the input file.
Increasing the sample rate, reduces the number of points extracted. As a result,
the image resolution is reduced, and the file is converted faster.
Point Colors Specifies how points are extracted from the input file.
Select from the following options:
■ None - the points come through as white.
■ Raw Intensity - the points use the intensity values stored in the file.
■ Color - the points use the color values stored in the file.
■ Color-Mapped Intensity - the points use a spectrum of RGB colors.
■ Gamma Corrected Intensity - the points use gamma-corrected raw
intensity values stored in the file.
Gamma Correction Level Specifies a gamma correction value used to adjust
the normalized point intensity values obtained from the file, and results in
lighter or darker images depending on the setting.
A gamma correction value in the range between 0.1 and 0.99 adjusts the
weighting of intensity values at the lower end of the intensity range, so that
the image appears lighter.
A gamma correction level above 1.0 has the effect of darkening the image.
NOTE A gamma correction of 1 means no changes.
See also:
Leica Scan File Reader (page 185)
804 | Chapter 17 Reference