2012

Table Of Contents
See also:
DWG/DXF File Reader (page 175)
Faro Page
Use this page to adjust the options for the Faro Scan file reader.
Point Colors Specifies how points are extracted from the input file.
Select from the following options:
None - the points come through as white.
Intensity - the points use the intensity values stored in the file.
Color - the points use the color values stored in the file.
NOTE If the selected option is not available, then the file reader defaults to the
values used in the file. For example, if you set Point Colors to Color, but only
intensities are available in the file, then the file reader uses the intensities.
See also:
Faro Scan File Reader (page 181)
FBX Page
Use this page to adjust the options for the FBX file reader.
Convert Autodesk Materials FBX files can contain either Autodesk or Native
materials. Select this check box to convert Autodesk materials. The exporter
will attempt to convert Autodesk materials, if they are available. Clear this
check box if you want to convert Native FBX materials to Presenter materials.
NOTE Presenter materials are only available when using Presenter graphics system,
and Autodesk materials (also referred to as consistent materials) are only available
when using Autodesk graphics system. See Graphics System (page 155).
Convert Lights Select this check box to convert lights.
When this check box is clear, the file reader ignores lights.
Convert Skeletons Select this check box to convert skeletons.
When this check box is clear, the file reader ignores skeletons.
Options Editor Dialog Box | 801