2012

When this check box is clear, the file reader ignores intensity values.
Use Point Color Values Select the check box to extract color values from the
input file.
When this check box is clear, the file reader ignores color values.
See also:
ASCII Laser Scan File Reader (page 171)
CIS/2 Page
Use this page to adjust the options for the CIS/2 file reader.
Convert Features Indicates whether features are converted.
NOTE Converting a large number of features may have a negative impact on the
loading performance.
Convert Unknown Section into Rectangle Select this check box to convert
unknown sections profiles into rectangles with estimated parameters, but the
scale may not be appropriate.
When this check box is clear, the file reader ignores unknown sections profiles.
Faceting Factor Enter the required value to control the level of faceting that
takes place.
The faceting factor must be greater or equal to 0, where 0 results in the faceting
factor being turned off. The default value is 1. To get twice the number of
facets, double this value. To get half as many facets, halve this value. Larger
faceting factors result in more polygons to a model and larger Autodesk
Navisworks files.
Max Facet Deviation This setting controls the greatest distance between the
edge of a facet and the actual geometry. If this distance is greater than the
Max Facet Deviation value, Autodesk Navisworks adds more facets.
If the Max Facet Deviation is set to 0, then this function is ignored.
DGN Page
Use this page to adjust the options for the 3D DGN and PROP file reader.
Faceting Factor Enter the required value to control the level of faceting that
takes place.
Options Editor Dialog Box | 793