2012

Units and Transform Dialog Box
Use this dialog box to adjust the units and file transforms for the 3D file
selected in the Selection Tree or the currently opened 2D sheet.
NOTE You can only adjust units and transforms for one 3D file or 2D sheet at a
time.
Model Units
Units Lets you choose the units for the loaded 3D model.
Sheet Units
Units Lets you choose the units for the loaded 2D sheet.
Origin
Origin Enter the X, Y, and Z coordinate values to move the file geometry
into this position.
NOTE Z coordinate values are not available for 2D sheets.
Reflected Transform Select this check box if you use a negative scale for your
transform.
NOTE Reflected Transform is not available for 2D sheets.
Rotation
Enter the rotation angle.
Select the rotation axis by entering values greater than 0. The model or sheet
geometry rotates about its origin point. Positive numbers rotate the model or
sheet counterclockwise; negative numbers rotate model or sheet clockwise.
Scale
Enter the scaling factor around X, Y, and Z axis for the file geometry; 1 being
the current size, 0.5 half, 2 being double and so on. To scale proportionally,
ensure the X, Y and Z scale values are equal. Entering negative values flips the
file geometry inside out.
NOTE Negative scale values cannot be used on 2D sheets. Also Z coordinate values
are not available for 2D sheets.
Units and Transform Dialog Box | 759