2011

Snap Size Enter a number from 1 through 9 to set the size (in pixels) of snap points drawn in the Scene View.
Enable Parametric Primitives Indicates whether Autodesk Navisworks dynamically renders parametric primitives
during interactive navigation.
Selecting this check box means the level of detail changes during navigation depending on the distance from
the camera.
Clear this check box to use the default representations of primitives; the level of detail stays the same during
navigation.
SpaceBall Page
Use the options on this page to customize the SpaceBall behavior.
These options are offered in addition to the adjustments that can be made using the Control Panel for the device
which is supplied by the SpaceBall manufacturer with the installation.
Scale Translation By Enter the value that is used to adjust the speed of translation.
Scale Rotation By Enter the value that is used to adjust the speed of rotation.
Navigation Mode Use the drop-down list to specify a default navigation mode for the SpaceBall. It is used when
no valid navigation mode is currently selected.
Navigation Bar Page
Use the options on this page to customize the behavior of tools on the navigation bar.
Orbit Tools
Use Classic Orbit Select this check box if you want to switch from the standard Orbit tool to the classic Autodesk
Navisworks Orbit mode on the navigation bar.
Use Classic Free Orbit (Examine) Select this check box if you want to switch from the standard Free Orbit tool
to the classic Autodesk Navisworks Examine mode on the navigation bar.
Use Classic Constrained Orbit (Turntable) Select this check box if you want to switch from the standard
Constrained Orbit tool to the classic Autodesk Navisworks Turntable mode on the navigation bar.
Walk Tool
Use Classic Walk Select this check box if you want to switch from the standard Walk tool to the classic Autodesk
Navisworks Walk mode on the navigation bar.
Constrain Walk Angle When this check box is selected, the Walk tool will keep the camera upright while
navigating. If this check box is clear, the tool will allow the camera to roll while navigating (resulting in behavior
almost like the Fly tool).
Use Viewpoint Linear Speed When this check box is selected, the Walk tool will respect the Viewpoint Linear
Speed setting. In this case, the Walk speed slider will act like a multiplier.
When this check box is clear, the Walk tool will work independently of the Viewpoint Linear Speed setting,
using a fixed value set with the slider.
Walk Speed Sets the speed of the Walk tool from 0.1 (very slow) to 10 (very fast).
ViewCube Page
Use the options on this page to customize the ViewCube behavior.
Show the ViewCube Indicates whether or not the ViewCube is displayed in the Scene View.
TIP You can also toggle the ViewCube by clicking View tab ➤ Navigation Aids panel ➤ ViewCube .
482 | Chapter 17 Autodesk Navisworks Reference