5.0

or referenced twice, for example.
To select the clash test options:
1. From the Run, Type drop down, choose the clash test type you wish to run. Any custom clash tests
that have been defined (see Creating custom clash tests) appear at the end of the list.
2. Enter the Tolerance required, which will be in scene units. See Clash Tolerance for more information
on this.
Time-based Clashing
If a JetStream TimeLiner license is available, the Link To TimeLiner check box will be available for
selection.
Linking to TimeLiner integrates the features of Clash Detective and TimeLiner, allowing the automation of
interference checking throughout the lifecycle of a TimeLiner project.
1. On clicking the Start button, if the Link To TimeLiner check box is checked, Clash Detective will
combine with TimeLiner to produce a clash report based on the Clash Detective settings, TimeLiner
simulation settings, and the project data contained in TimeLiner.
2. As the TimeLiner project simulation progresses forward in time, Clash Detective will check at each
interval in the project to see if there are any clashes present. Once the simulation is complete, any
clashes found in this manner will be shown in the Results tab alongside TimeLiner project
information. See the following chapter on Results for more information.
Note
If the TimeLiner project is large in size, running this type of clash test will invariably take more
time to complete than a normal clash run.
Running the clash test
Selecting Items for Clash Testing
353