2010

Table Of Contents
4 With the clip selected in the Trax Editor, open the Attribute Editor. Open
the Channel Offsets menu and ensure that the WalkCycle clips root.scale
and root.translate offset attributes are set to Relative and root.rotate offset
attributes are set to Absolute.
Setting the offset attributes for the clip to Relative ensures that each cycle
begins at the position where the last sequence left off. This ensures that
the skeleton doesnt jump back to its start point after each cycle.
5 Click play on the Time Slider playback controls to play back the clip.
The skeleton takes six steps and then stops.
When the clip is cycled twice, the two-step walking motion occurs three
times in total.
6 Press stop on the playback controls to stop the playback and reset the
current time indicator to frame 1.
Extending the length of motion capture data | 265