2010

Table Of Contents
If your skeleton doesnt appear as shown, you will need to increase the
size of the skeletons joints.
To resize the joints on the skeleton
1 From the main menu, select Display > Animation > Joint Size.
The Joint Display Scale window appears.
2 Set the Joint Display Scale to 10.
3 Close the Joint Display Scale window.
To preview the motion capture animation
1 Click play on the Time Slider playback controls to play back the
animation.
The skeleton is repositioned and then walks from left to right, stops, and
then sits.
2 Press stop on the Time Sliders playback control.
Creating clips from motion capture data
When creating a clip from motion capture, it is a good practice to begin by
creating a source clip from the entire motion sequence that excludes the Da
Vinci pose. You can create the clip and save it to the Visor or Outliner directly
without loading it onto a track. You can later revert back to the source clip
and load it into a track if necessary.
To create a source clip of the motion capture data
1 In the Time Slider, set the Playback Start Time to 1.
2 Press the Go to Start of playback range button to return to frame 1 in the
Time Slider.
The skeleton is repositioned at frame 1 where the walking motion begins.
260 | Chapter 6 Animation