2010

Table Of Contents
6 Drag the red arrow on the Move manipulator downwards to move the
vertices so that the shape of the faces for the grill are more diagonal (see
image).
NOTE Make sure you do not move the vertices so that the lowest vertex
touches the corner vertices or youll create an edge that has zero length.
7 Click off the mesh to deselect the vertices.
8 Before proceeding to the next section, double-click the Move Tool and
reset the tool settings by clicking the Reset Tool button.
To make the grill vents three-dimensional, youll extrude some of the thin
diagonal faces inwards.
To extrude the faces for the grill feature
1 Right-click the helmet mesh and change the selection mode to Face.
2 Beginning at the bottom of the grill feature, shift-select the two diagonal
faces as indicated in the image below.
Splitting polygon faces | 113