Shortcut Key Guide

TABLE OF CONTENTS

One Key Shortcuts

Keyboard Diagram ..................................................................... 3

Printable Keyboard Stickers ........................................................ 14

Keyboard Shortcut

Commands by Category

Assembly ................................................................................... 4

Drawing Manager ...................................................................... 4

General ...................................................................................... 4

Part ............................................................................................ 4

Placed Features .......................................................................... 4

Sketch ....................................................................................... 5

Tools .......................................................................................... 5

View .......................................................................................... 5

Work Features ........................................................................... 5

Multi-Character Command

Aliases by Category

Annotation ................................................................................ 6

Assembly ................................................................................... 6

Cable & Harness ........................................................................ 6-7

Dimension ................................................................................. 7

Drawing Manager ...................................................................... 8

Dynamic Simulation ................................................................... 8

Frame Analysis ........................................................................... 8-9

Mold Design .............................................................................. 9-10

Part ............................................................................................ 10

Placed Features .......................................................................... 11

Presentation ............................................................................... 11

Sheet Metal ............................................................................... 11

Sketch ....................................................................................... 11-12

Sketch Features .......................................................................... 12

Stress Analysis ............................................................................ 12-13

Tools .......................................................................................... 13

Tube & Pipe ............................................................................... 13

View .......................................................................................... 13

NOTE: To enable the use of multi-character command aliases in Inventor, make

sure the “Use default multi-character Command Aliases” option is checked.

To access this, select Tools tabOptions panelCustomize, and click the

Keyboard tab.