Shortcut Key Guide

12
MULTI-CHARACTER COMMAND ALIASES
Sketch
MO MOVE / Moves selected sketch geometry
from point to point, or move a copy of the
geometry.
O OFFSET / Duplicates selected sketch
geometry, and positions it an offset
distance from the original.
PO POINT, CENTER POINT / Sketches points
and center points.
POL POLYGON / Creates polygon shapes.
REC TWO POINT RECTANGLE / Draws a
two-point rectangle using dynamic input.
REC3 THREE POINT RECTANGLE / Draws a
three-point rectangle using dynamic input.
RO ROTATE COMPONENT / Activates the
Rotate Component command.
RP RECTANGULAR PATTERN / Creates
rectangular pattern of sketch geometry.
SP SPLINE / Creates a spline.
TC TANGENT CIRCLE / Creates circle tangent
to three lines.
X TRIM / Activates the Trim command.
Sketch Features
BP BEND PART / Bends a portion of a part.
E EXTRUDE / Extrudes a prole.
H HOLE / Creates a hole in a feature.
LO LOFT / Creates lofted features or bodies
by blending multiple proles into smooth
shapes between the proles or part faces.
R REVOLVE / Revolves a sketch.
SW SWEEP / Creates a sweep feature.
Stress Analysis
A ANIMATE RESULTS / Animates the
selected simulation results.
AC AUTOMATIC CONTACTS / Compares
automatic contacts.
BC BOUNDARY CONDITIONS / Toggles
display of all boundary conditions.
BE BEARING LOAD / Applies a bearing load
to a full or partial cylindrical surface.
BO BODY LOAD / Denes angular velocity
or angular or linear acceleration for the
model.
CC COLOR BAR / Displays the Color Bar
settings dialog box where you adjust the
color bar display parameters.
CF FIXED CONSTRAINT / Applies a xed
constraint on selected faces, edges, or
vertices.
CP CONVERGENCE PLOT / Displays the plot
within a dialog box.*
CP PIN CONSTRAINT / Sets the pinned
constraint origin and offset.*
CS FRICTIONLESS CONSTRAINT / Applies a
frictionless constraint on selected faces.
CT CONTOUR SHADING / Displays color
changes using a strict banding between
colors.
FO FORCE LOAD / Applies a force of the
specied magnitude to the selected faces,
edges, or vertices.
GR GRAVITY LOAD / Creates a gravity load.
MAT ASSIGN MATERIALS / Opens the assign
materials dialogue box to assign materials
to a component.
MAX MAXIMUM RESULT / Turns on and off
the display of the point of maximum result
in the mode.
MC MANUAL CONTACT / Adds manual
contact conditions to selected geometry
elements.
MIN MINIMUM RESULT / Turns on and off the
display of the point of minimum result in
the model.
ML LOCAL MESH CONTROL / Adds a local
mesh control.
MO MOMENT LOAD / Applies a load of the
specied magnitude around the axis and
perpendicular to the face.
MS MESH SETTINGS / Species the mesh
sizing and coarseness.
*NOTE: The same alias can perform different commands depending on the design environment and object you are working on.