2009

NOTE Since you selected a category early on in the process, the Content Center
displays this category for publishing. For example, a bolt can now be published
directly into the Bolt category, an existing subcategory of Bolt, or you can create
a category under Bolt.
NOTE You can rename the iMates as needed. These new names populate the
iMate list in both the panel browser and the Component Authoring dialog under
the iMate list.
Set File Names
The Design Accelerator Settings dialog box is available to change or redefine
the Display name and the File name for Design Accelerator generators and
calculators.
Use the File Naming dialog to specify the name of the connection and newly
created components lets you change the filename and location on disk.
When you work in any generator or calculator, V-Belts Generator foe example,
you click the File Naming icon in the right upper corner. The File Naming
icon is available within all tabs (Design, Calculation, Fatigue Calculation).
Double-click the row to enter the Displayed name, V-Belt transmission1, for
example. The name can contain letters, numbers, or any symbol.
To specify the file name location, click the button next to the selected row.
The button is available only for one selected row at a time. In the selected
folder, the component is stored.
When you select the Always prompt for filename option, you are prompted
to specify file name and display name every time you insert a new DAcc
component into the assembly. During edit, the dialog is displayed only if you
add a new component, a new pulley using V-Belts Generator, for example.
Set File Names | 201