2010
Table Of Contents
- Contents
- Part 1 Stress Analysis
- 1 Get Started With Stress Analysis
- 2 Analyze Models
- 3 View Results
- 4 Revise Models and Stress Analyses
- 5 Generate Reports
- 6 Manage Stress Analysis Files
- Part 2 Dynamic Simulation
- Index
4 In the browser, expand the Blade set assembly node to expose the
components.
5 Select the Scottish Yoke component. On the Quick Access Toolbar, change
the color to Chrome.
NOTE If you receive a Design View Representation message about color
associativity, select Remove associativity and click OK.
6 Add a mate constraint between the Scottish Yoke and Guide to position
the yoke on top of the guide.
62 | Chapter 10 Construct Operating Conditions