2009
Table Of Contents
- Contents
- Stress Analysis
- 1 Get Started With Stress Analysis
- 2 Analyze Models
- 3 View Results
- 4 Revise Models and Stress Analyses
- 5 Generate Reports
- 6 Manage Stress Analysis Files
- Simulation
- Index
7 Click OK. Return to the default isometric view.
8 Drag and position the door approximately, as shown.
9 Click Run on the Simulation Panel. The parts move as a unified
mechanism.
10 If the simulation is still running, click the Stop button.
11 Click the Activate construction mode button.
Next, you use a contact joint between the door and pillar parts to stop the
door when it reaches the tab stop.
Insert a contact joint
1 Click the Insert Joint tool, and then select 2D Contact joint.
2 Select the bottom face of the door.
64 | Chapter 9 Construct Moving Assemblies