2009

You can define and edit parameters at any time, either during part modeling,
analysis setup, or post-processing. If you change the parameters associated
with a load or constraint after a solution is obtained, the Update command
is enabled so you can run a new solution.
You cannot delete the system-generated parameters, although they are deleted
automatically if their associated loads or constraints are deleted. You also
cannot delete parameters that are currently used by a system-generated
parameter.
Feature Suppression Tracking
When conducting analysis studies, you may need to tailor portions of a model
to allow for a more efficient analysis. Generally, this technique involves
removing geometrically small features which only complicated the mesh,
without significant effects to the final result.
Setting Solution Options
Before starting your solution, set the analysis type and mesh relevance for the
analysis, and then specify whether to create new analysis file. Select Stress
Analysis Settings from the stress analysis panel bar to open the dialog box.
When you finish setting the options, click OK to commit them.
Feature Suppression Tracking | 21