2009

Loads and constraints are listed under Loads & Constraints in the browser. If
you right-click a load or constraint in the browser, you can:
■ Edit the item. The dialog box for that item opens so that you can make
changes.
■ Delete the item.
To rename an item in the browser, click it, enter a new name, and then press
ENTER.
Running Stress Analysis
Once you build or load a part, you can run an analysis to evaluate it for its
intended use. You can perform either a stress analysis or a resonant frequency
analysis of your part under defined conditions. Use the same workflow steps
in either analysis.
The following are the basic steps to perform a stress or resonant frequency
analysis on a part design.
14 | Chapter 2 Analyze Models