2010
Table Of Contents
- Contents
- Part 1 Tubes and Pipes
- 1 Get Started with Tube & Pipe
- 2 Route Basics
- 3 Set Styles
- 4 Create Rigid Routes and Runs
- Workflow for Rigid Routes
- Create Auto Route Regions
- Manually Create Parametric Regions
- Automatically Dimension Route Sketches
- Create Segments With Precise Values
- Define Parallel and Perpendicular Segments
- Snap Route Points to Existing Geometry
- Place Constraints On Route Sketches
- Create Bends Between Existing Pipe Segments
- Create Pipe Routes With Custom Bends
- Create Bent Tube Routes
- Realign 3D Orthogonal Route Tool
- Control Dimension Visibility
- Populated Routes
- 5 Create and Edit Flexible Hose Routes
- 6 Edit Rigid Routes and Runs
- 7 Use Content Center Libraries
- 8 Author and Publish
- 9 Document Routes and Runs
- Part 2 Cable and Harness
- 10 Get Started with Cable and Harness
- 11 Work With Harness Assemblies
- 12 Use the Cable and Harness Library
- 13 Work with Wires and Cables
- 14 Work with Segments
- 15 Route Wires and Cables
- 16 Work with Splices
- 17 Work with Ribbon Cables
- 18 Generate Reports
- 19 Work With Nailboards and Drawings
- Part 3 IDF Translator
- Index
7 Click Table Layout, and then use the Table Layout dialog box to change
the title of the table to Enclosure Harness Assembly BOM. If appropriate,
make additional changes to the table, and then select OK.
Placing Connector Views
You can also add connectors to complete the harness information using the
Place Connector Views tool. You can set the default display characteristics
before placing the connectors, or you can override the defaults on selected
connectors while placing them.
For this exercise, you place two connector views using default display settings
and then override the default display settings for the other connector.
1
In the drawing view, click Nailboard tab ➤ Create panel ➤
Place Connector Views.
2 In the connector list, clear the check box for LTP:1, and then click OK.
The selected connectors are placed using the default display settings.
3 Click the Place Connector Views tool again.
4 Under Orientation, click the arrow to select ISO Top Right from the list,
and then Click OK.
360 | Chapter 19 Work With Nailboards and Drawings